TCAN4550 nINT中断到M3连接如上图所示。 M3想尽快收到CAN总线上的报文，以减少TCAN4550转换带来的通信延迟。 1、这里想通过nINT中断方式通知M3，当有外部中断来的时候，在M3的外部中断中进行接收消息标志位检测，，如果有消息，则读取CAN消息放至本地的接收队列中 ...

dac_trigger.SOFT_RESET = 10; // 当设置为保留码A(1010)时，该位复位设备到默认状态。这些位是自我复位的。 dac_trigger.LDAC = 0; // 将此位设置为1，以同步模式同步加载DAC，此位是自复位。 dac_send_data(DACx0501_TRIGGER, dac_trigger.Trigger); dac_sync.DAC_SYNC_EN ...

设置SPI多个片选引脚除了config里面定义的其余引脚是否需要用GPIO虚拟，同时虚拟出来的引脚对传输速率是否有影响 可以使用GPIO模拟，在每次SPI发送之前，对SPI的片选信号也会进行控制，所以SPI的片选信号就是在每次需要发送到某个设备的时候，将CS片选端进行 ...

In theory this should be possible since LIN is a single wire protocol. However, we do not have a plan to support this.

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

Using CCSv12.6.0 + C2000Ware 5.01 to setup a working Target config for LAUNCHXL_F28P65x: Is there a known issue? Can you please help with the below error message? I ...

We are not able to find the User's Guide for the LAUNCHXL2-570LC43 eval board. I think it is not available for this device. Can you please refer schematic and quick start guide instead of it.

Hi! I am working with INA333 to amplify a wheatstone bridge output voltage. Here is the circuit in KiCAD: I am testing the circuit with the INA output connected to a stm32f405-microcontroller ADC pin.

We are trying to connect an SD card to the MMC2 Port on our system, we have enabled the sdhci2 on your device tree, but it seems it is not working , i mean when card is connected we are not able to ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

During the charging and discharging process, the FCC value suddenly jumps to 0, but after a period of time it returns to a smaller value, or returns to a normal value Attached are the machine LOG and ...

Referring to the list of clock identifiers in the link and also refer the clock summary taken from /sys/kernel/debug/clk ...