TCAN4550 nINT中断到M3连接如上图所示。 M3想尽快收到CAN总线上的报文，以减少TCAN4550转换带来的通信延迟。 1、这里想通过nINT中断方式通知M3，当有外部中断来的时候，在M3的外部中断中进行接收消息标志位检测，，如果有消息，则读取CAN消息放至本地的接收队列中 ...

dac_trigger.SOFT_RESET = 10; // 当设置为保留码A(1010)时，该位复位设备到默认状态。这些位是自我复位的。 dac_trigger.LDAC = 0; // 将此位设置为1，以同步模式同步加载DAC，此位是自复位。 dac_send_data(DACx0501_TRIGGER, dac_trigger.Trigger); dac_sync.DAC_SYNC_EN ...

设置SPI多个片选引脚除了config里面定义的其余引脚是否需要用GPIO虚拟，同时虚拟出来的引脚对传输速率是否有影响 可以使用GPIO模拟，在每次SPI发送之前，对SPI的片选信号也会进行控制，所以SPI的片选信号就是在每次需要发送到某个设备的时候，将CS片选端进行 ...

We are using THS4521 for converting single-ended to differential signal. Differential signals are going out of the board via ethernet cable to MCU ADC on the other board. - MCU ADC configuration is in ...

I have made a temperature sensor with two endpoints: one for a SHT sensor and another one for an NTC. Everything seems to work as intended and the sensor reports all values correctly, however it seems ...

In theory this should be possible since LIN is a single wire protocol. However, we do not have a plan to support this.

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

Check the generated file test.json, the 0x34, 0x38, 0x3C are configured to select PDM1 PDM1 and echo as channel0, channel1 channel2 in the I2S/TDM commnuication. 6. Copy the test.bin to the kernel and ...

Using CCSv12.6.0 + C2000Ware 5.01 to setup a working Target config for LAUNCHXL_F28P65x: Is there a known issue? Can you please help with the below error message? I ...

Hi! I am working with INA333 to amplify a wheatstone bridge output voltage. Here is the circuit in KiCAD: I am testing the circuit with the INA output connected to a stm32f405-microcontroller ADC pin.

We are not able to find the User's Guide for the LAUNCHXL2-570LC43 eval board. I think it is not available for this device. Can you please refer schematic and quick start guide instead of it.

im just getting started working on the API integration of my client to your Rest-API. As im setting everything up, i encountered several problems regarding your store-order-api.