I am trying to use string concat , strcpy , strcmp function for example testData[10] = {'\x02', 'A', 'B', 'C','2', 'D','0','M','\x03'}; to concat this testData to a ...

In theory this should be possible since LIN is a single wire protocol. However, we do not have a plan to support this.

Using CCSv12.6.0 + C2000Ware 5.01 to setup a working Target config for LAUNCHXL_F28P65x: Is there a known issue? Can you please help with the below error message? I ...

We are not able to find the User's Guide for the LAUNCHXL2-570LC43 eval board. I think it is not available for this device. Can you please refer schematic and quick start guide instead of it.

James Evans said that never set interrupt enable other than master channel. But, if so, we can't set preload which bigger than master channel's preload to another channels. Because when interrupt ...

Check the generated file test.json, the 0x34, 0x38, 0x3C are configured to select PDM1 PDM1 and echo as channel0, channel1 channel2 in the I2S/TDM commnuication. 6. Copy the test.bin to the kernel and ...

I am facing a issue when using safety library to execute SRAM_ECC_ERROR_FORCING_2BIT,SRAM_ECC_ERROR_FORCING_1BIT selft test. This issue is only observed when application is combined with a boot loader ...

Hi! I am working with INA333 to amplify a wheatstone bridge output voltage. Here is the circuit in KiCAD: I am testing the circuit with the INA output connected to a stm32f405-microcontroller ADC pin.

If a place a Voltage Generator on a new schematic and then attempt to change the signal type (from the default Unit step) to any other type (e.g. sine wave) then Tina ...

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

When I read the values in the Registers Table in BQStudio for my battery assembly I see a voltage value of 7656 mV and individual cell voltage of 3830 mV (Cell 1), 3827 mV (Cell 2) and 3834 mV (Cell 3 ...

im just getting started working on the API integration of my client to your Rest-API. As im setting everything up, i encountered several problems regarding your store-order-api.